Product was successfully added to your shopping cart.

OS-400

Description

OS-400 is specifically designed for double 5/8” drywall applications and outside 90º corners where there are large drywall irregularities. OS-400, a paper-faced composite corner bead from Strait-Flex, beautifully finishes outside 90º corners and is the largest outside corner bead on the market. This 4” corner bead applies with all-purpose compound and features a pre-finished laminated nose ensuring a clean sharp corner. The laminated nose eliminates the risk of damage from a taping knife, will not shrink, and will not fuzz up during sanding. The bead’s outer edge features a diamond punch pattern for easier feathering, faster drying, and the highest bonding strength. The backing of OS-400 is Strait-Flex’s patented composite material creating an incredibly strong corner.


  • Double 5/8” drywall applications and outside 90º corners where there are large drywall irregularities. 

  • Diamond-punched 94 lb. paper edging allows for easier feathering, faster drying, and the highest bonding strength. Also guarantees an even lay-down of the paper, providing maximum adhesion with no rippling or blistering.

  • Clean installation. 

  • Composite backing provides a tough, durable corner with no rust.

  • PUR-laminated nose resists dents and ensures perfect corners without paper fuzz-up during finishing and sanding.

Size: 4”w (102mm)
COLOR CODE BLACK

Installation

Cut Strait-Flex OS-400 to measured length.

For vertical corners, cut 1/4” short of floor.

Apply all-purpose joint compound with Mud-Pro2 (compound applicator) to corner bead; or apply compound to outside corners with a 5” or 6” taping knife.

Press corner bead into wet compound by hand or use Strait-Flex’s OS-400 Rolling Tool for fastest results.

Adjust if necessary to create a straight line.

Wipe down edges and let dry.

Apply final coat, let dry, and sand.

REPAIRS OVER PAINTED SURFACES

Strait-Flex recommends the use of Strait-Flex Super-Bond or latex paint, mixed with all-purpose joint compound to enhance bondability.

Additional Information

Bullet Points No
Instructions for Use

Cut Strait-Flex OS-400 to measured length.

For vertical corners, cut 1/4” short of floor.

Apply all-purpose joint compound with Mud-Pro2 (compound applicator) to corner bead; or apply compound to outside corners with a 5” or 6” taping knife.

Press corner bead into wet compound by hand or use Strait-Flex’s OS-400 Rolling Tool for fastest results.

Adjust if necessary to create a straight line.

Wipe down edges and let dry.

Apply final coat, let dry, and sand.

REPAIRS OVER PAINTED SURFACES

Strait-Flex recommends the use of Strait-Flex Super-Bond or latex paint, mixed with all-purpose joint compound to enhance bondability.

Size 4”w (102mm)
Instructions PDF No
Submittal PDF /media/wysiwyg/straitflex/submtl/Submtl_Sheets_OS400.pdf
Testimonial PDF No
Warranty PDF No
Bulk Order Page URL N/A

Also Purchased