Product was successfully added to your shopping cart.

Ultra-90º

Description

Ultra-90º is superior in repairing damaged corner bead without remove the existing corner bead. Ultra-90º is twice as fast, twice as strong, finishes in one coat, resulting in half of the work than using conventional methods. The pre-finished laminated center section of Ultra-90º ensures a clean, sharp corner without the risk of damage from a taping knife, will not shrink, and will not fuzz up during sanding. Ultra-90º also repairs cracked or damaged metal corner bead without removing the corner bead. The tape’s outer edge features a diamond punch pattern for a superior bond, faster drying, with no rippling or blistering.


  • Inside and outside corners and angled corners

  • Twice as fast and twice as strong as conventional paper or mesh tapes.

  • Straightens most inside and outside corner imperfections.

  • No delayed shrinkage.

  • Repairs damaged metal corner bead without removal of bead. 

  • No compound required over pre-finished surface. Finishes corners in one coat, cutting the finish time in half. 

  • PUR-laminated center ensures perfect corners without paper fuzz-up.

  • .035” thickness

Size: 3”w (76mm)
COLOR CODE BLUE

Installation

To apply, measure and cut to length, then fold in half at center crease with print side facing out.

For repairing damaged corner bead, tap the damaged area of the corner bead to recess below the corner’s edge.

Apply all-purpose compound to corner.

Press Ultra-90º into the wet compound, adjust to create a straight line, and wipe down tight with a taping knife, and let dry.

Apply a light skim coat to the perforated edges, let dry, and sand.

You do not need to apply compound or sand the center section of the tape.

REPAIRS OVER PAINTED SURFACES.

Strait-Flex recommends the use of Strait-Flex Super-Bond or latex paint, mixed with all-purpose joint compound to enhance bondability.

Additional Information

Bullet Points No
Instructions for Use

To apply, measure and cut to length, then fold in half at center crease with print side facing out.

For repairing damaged corner bead, tap the damaged area of the corner bead to recess below the corner’s edge.

Apply all-purpose compound to corner.

Press Ultra-90º into the wet compound, adjust to create a straight line, and wipe down tight with a taping knife, and let dry.

Apply a light skim coat to the perforated edges, let dry, and sand.

You do not need to apply compound or sand the center section of the tape.

REPAIRS OVER PAINTED SURFACES.

Strait-Flex recommends the use of Strait-Flex Super-Bond or latex paint, mixed with all-purpose joint compound to enhance bondability.

Size 3”w (76mm)
Instructions PDF No
Submittal PDF /media/wysiwyg/straitflex/submtl/Submtl_Sheets_Ultra90.pdf
Testimonial PDF No
Warranty PDF No
Bulk Order Page URL N/A

Also Purchased