Product was successfully added to your shopping cart.

Edge-Tape

Description

Edge-Tape, a paper-faced, laminated composite edge tape from Strait-Flex, creates clean, straight edges, is twice as fast, and uses half the compound compared to tear-off bead. Edge-Tape is installed by the finisher and not by the carpenter; and is installed with standard compounds. This 2” tape finishes drywall edge for Commercial “Top Out” applications where drywall meets concrete ceilings, suspended ceilings, window returns, fiberglass tubs, and sky lights. The tape’s outer edge features a diamond punch pattern for a superior bond, faster drying, with no rippling or blistering. 100 foot rolls reduce waste up to 20% compared to tear-off bead.


  • Commercial “Top Out” applications, suspended ceilings, window returns, fiberglass tubs, and sky lights.

  • 100 foot roll reduces waste up to 20%

  • Installs using standard compounds. No staples or glue.

  • Installs by finisher, not by carpenter.

  • Rustproof. Water-resistant.

Size: 2”w (51mm)
COLOR CODE GREEN

Installation

With a 4” or 5” taping knife, apply a smooth, liberal coat of compound to drywall edge.

Press Edge-Tape into the wet compound.

Adjust if necessary to create a straight line.

Wipe down tight with taping knife using a little additional pressure on the outer edges of Edge-Tape.

Immediately apply a light skim coat of compound over perforated edge.

Wipe down smooth.

Let dry completely over several hours or overnight.

With 6” or 8” taping knife, apply your final coat of compound feathering the compound beyond previous coat.

Let dry completely over several hours or overnight.

Sand lightly with 120 grit sandpaper.

Edge-Tape will not fuzz-up like paper or mesh tapes.

Additional Information

Bullet Points No
Instructions for Use

With a 4” or 5” taping knife, apply a smooth, liberal coat of compound to drywall edge.

Press Edge-Tape into the wet compound.

Adjust if necessary to create a straight line.

Wipe down tight with taping knife using a little additional pressure on the outer edges of Edge-Tape.

Immediately apply a light skim coat of compound over perforated edge.

Wipe down smooth.

Let dry completely over several hours or overnight.

With 6” or 8” taping knife, apply your final coat of compound feathering the compound beyond previous coat.

Let dry completely over several hours or overnight.

Sand lightly with 120 grit sandpaper.

Edge-Tape will not fuzz-up like paper or mesh tapes.

Size 2”w (51mm)
Instructions PDF No
Submittal PDF /media/wysiwyg/straitflex/submtl/Submtl_Sheets_EdgeTape.pdf
Testimonial PDF No
Warranty PDF No
Bulk Order Page URL N/A

Also Purchased